|
Install
Guide:
Perfect
Application: Wash your hands!! Anything on your fingers will attach
to the sticky section of the lens cover. Liberally spray some of the easy
positioning liquid (included in kit) onto the lens you are about
to cover. Peal off the paper backing from one side (or both) of the Headlight
Protector. Press the Headlight Protector
to the lens starting at one edge. With moderate pressure, sweep the surface
of the Headlight Protector across the lens
surface. The Headlight
Protector will adhere to lens but will me movable. Work slowly
as you pull back another 1 to 1 1/2" of paper until the lens has
been fully covered. Position accordingly. Press any remaining large air
bubbles out to the edges of the lens. Smaller air
bubbles and/or moisture will disappear over time but may take up to 3
weeks to completely disappear. Do not wash the vehicle for 48 hours
following application to allow the adhesive to set.
Disclaimer:
These shields will not protect your headlights from all impacts. Extreme
impacts or cold water on hot lights (shock) may brake lights. Pirates'
Lair is not responsible for any damage to lights while the
Headlight Protector is in use.
|